Hobby Projects - Insulation tester, LED Circuits, Meters.

Saturday, April 15, 2017

Development boards and Tools - OLIMEX

Designs, prototypes and manufactures printed circuit boards, sub-assemblies and complete electonic products.

Development boards and Tools - OLIMEX

64MB SDRAM, 512MB NAND Flash. Ethernet 100Mbit controller, USB host, USB device, RS232 and 40 pin extension port with all unused SAM9261 ports available for add-on boards. Runs Linux, WindowsCE and other RTOS natively. RTC - 3V Li battery.

SAM9-L9261 Development Platform with ARM9

SAM9-L9261 Development Platform with ARM9

SAM9-L9261 is development platform with ARM9 microcontroller, TFT LCD 3.5" 320x240 pixels with TOUCHSCREEN.
  • MCU: AT91SAM9261 16/32 bit ARM9 180MHz operation
  • On board voltage regulator 3.3V with up to 800mA current
OLIMEX Ltd.
89 Slavjanska St., P.O.Box 237, Plovdiv 4000 BULGARIA

555 and CD4017 Running Lights

This is a Gadget Tutorial for this Article LED Running lights CD4017 - Live Gadget Page.

Red Button Powers LED Running Lights, 555 Clock is counted by CD4017. Adjust R2, See ToolTips. This Demo shows LM555 running a CD4017 Counter to drive Ten Leds sequentially.

Press the Red button below to turn on the circuit press it again to turn off, i have put a new battery and did the wiring for you. The Red LED will flash according to the state of the 555 output at pin 3. The decade counter-divider CD4017 has 10 outputs, for every low to high transition, rising edge, the counter advances one LED. After going one full circle the the first LED lights again and it goes on.....

LED Running lights CD4017

The 10 outputs have 10 green LEDs. The current thru the LED is limited by R1, the current can be calculated like this (9V - 1.6V) / 1K = 7.4mA this is within 20mA which is the danger limit of the CMOS output. You want it to be bright use transistors for every output.

Friday, April 07, 2017

Build Electronic Circuits Like a Pro

If you want to build electronic circuits, you need to connect the components of your circuit somehow. If you expect to make your circuit work more than just a few times, you need a solid way of connecting them. You need to create a printed circuit board (PCB).

"I started playing with electronics as a hobby when I was 14. Since then I have finished a Master's degree and founded two electronic design companies."

Build Electronic Circuits Like a Pro

Build Electronic Circuits Like a Pro

The radar sensor uses a Ultra-Wideband (UWB) chip from Novelda. It sends out electromagnetic pulses and analyzes the pulses that are reflected back. In the video above, a part of the electromagnetic pulse will be reflected back when it hits the wall and a part of it penetrates the wall and is reflected from the cabinet behind the wall.

Radar Circuit Enables See-through Wall Robot

delabs Notes

This is a nice Educational Website built by Oyvind from Norway. Only when we read and learn from the experience and views of others, our brain opens up to new ideas and we develop a wide perspective.