Hobby Projects - Insulation tester, LED Circuits, Meters.

Thursday, October 17, 2013

LM317 based Regulated Power Supply

This is a Regulated Power Supply based on the LM317 IC. It will need a Boost Power Transistor and heatsink for higher currents. It is a versatile building block for stable instrumentation supplies. Consumer Electronic gadgets can use a SMPS chip. In case you wish to use a SMPS for a Precision Instrumentation Block, then take extreme care on Shielding and EMI-RFI.

LM317 based Regulated Power Supply

This is a General Purpose Chip, Series Regulation. It can be varied or trimmed. There is an Internal temperature compensated reference. The minimum trim value is around 1.2. In case you want a Low value voltage like 0.5 with a good current, then use a good negative supply to offset the 1.2 V.

The transformer can be s Split Bobbin with Pri-Sec copper shield foil.  This can be earthed along with the metal enclosure. C4 sends any hi-freq components to earth.  It is better if you do not earth the ground but use such capacitors. A Supply should simulate a a battery with both ends floating wrt Earth. A option to eartth the ground is fine. This also helps the user to configure his own dual supplies.

Q1 and R5 form a Short Circuit OR current fold back OR constant current mechanism. TP1 can be used to vary the output voltage.  Better use something like a Bourns 10T trimpot. An open preset may introduce a noise due to dust and vibration. I don’t remember why i added a zener DZ1, a diode may suffice.

See more at my Power Supplies Section.